Company Info

Railing and Skylights

         Railing
         Skylights
         Shades
         Solatube
Distributors
Events
Contact Us

Request information

Our Home Page

Gallery | Installation | Flash Kit Instructions
Product Information | Order Form

Product Information

Western Skylights are, simply put, made well. Visible quality is obvious when looking at the skylight and especially obvious when viewing a cross section.

FRAME CONSTRUCTION / DESIGN

The outer frame is 6063-T5 aluminum anodized medium bronze. Corners are folded from continuous pieces rather than welded & painted or screwed together. This frame design gives UV shielding protection to the sealants for longer life and provides a cleaner, more finished appearance.

The lack of welds, holes or screws on the exterior contributes to the low failure rate of Western Skylights, and allows us to provide our unequaled $100 back plus replacement guarantee.

The welded PVC inner frame is snapped to the aluminum outer frame around the entire perimeter of the glass, providing a constant and continuous compression force on the sealing tape. Screw together frames have "hard" spots where the screws are located and “soft” areas where the inner frame can sag between the screws allowing for uneven seal compression. The snap together design provides state of the art thermo break technology as well as an excellent condensation drainage system.



GLASS

Glass units are 7/8” overall insulated glass. The exterior pane is tempered glass and the interior pane can be either tempered or laminated glass (tempered glass is standard). Other glass configurations are available (low E, bronze, obscure, etc.). The entire unit is sealed using a two-part polyisobutylene and silicone process.

ACRYLIC

There are two primary materials used in plastic skylights today, polycarbonate and acrylic.

Polycarbonate, also known as Uvex and Lexan, is extremely strong. It has a negative reputation for discoloring in the presence of sunlight, however, and is not acceptable in Western Skylights.

Acrylic is clearer, 12 times stronger than glass, will not yellow or discolor and forms into optically distortion free domes. Lower grades of acrylic are available and often used by other manufacturers, but due to surface ripple and reduced strength in the lower grades, Western Skylights uses only top quality acrylic.

In response to customer preference, the acrylic is formed to a low-rise dome with an air space designed to provide maximum thermal efficiency.

SEALANT

Foam tape specifically designed for this application and with built in UV inhibitors is used with the proper amount of compression to insure a weather tight seal.

PACKAGING

All standard units are shipped in 200 lb. test boxes. Acrylic skylights are additionally protected with 275 lb. test corner supports and internal padding to protect the glazing from scratching in transit and storage. They can be stacked up to 15 high because of the internal reinforcement and are clearly marked on the end with the part number, color and configuration.

SIZING

The sizing of each skylight, both fixed and opening, is predicated on standard rafter spacing (exception is the 34xx series). All units are designed to fit either vertically or horizontally and align with combinations of rafters. Additionally, opening models fit the same curbs as fixed models. Custom sizes or shapes are also available to accommodate unusual or non-standard applications.

WESTERN SKYLIGHTS WARRANTY

All Western Skylights are warranted for a period of five years from the date of purchase against defects in materials and workmanship. Defective units must be returned to the factory along with the purchase receipt. Western Skylights are also covered by a $100 labor reimbursement to the original purchaser to compensate time and effort in handling a leakage claim. This labor warranty only applies to leakage. It is in addition to our standard product warranty and is subject to verification of leakage at our factory.

KDL Enterprises, Inc. will repair or replace, at its option, a defective unit at no charge as long as no damage, modification or evidence of disassembly exists. Spontaneous bursting of tempered glass or cracking of laminated glass is not warranted by the glass suppliers and is therefore not covered under our warranty terms. A discounted repair charge is, however, available.

KDL Enterprises, Inc.
7818 South 194th St.
Kent, WA 98032
1-800-642-9179